As our Hardware Engineer, you'll own the hardware side of the Anori BMS with a focus on the power stage: power electronics, cell connection and protection circuits.
At the same time, you'll be our go-to person for hardware testing and make sure every board holds up under real-world conditions, from HiL test benches to stress tests and EMC pre-compliance.
You'll work closely with Stefan, our CTO, and our firmware engineers to take the BMS from a tested prototype to a fully certified product.
The technology is proven, the funding is secured, and the hardware decisions you make now will define how every future Anori BMS works.
Start date: from January 1, 2027What You'll DoDesign and develop the power stage of our BMS: the highest power density on the marketMake the trade-off between performance, reliability, supply chain and price for each partBuild and run hardware tests: HiL setups, stress tests, HALTs and failure analysisPlan and run EMC pre-compliance testing and prepare the path to conformityBring up new boards and debug them together with the firmware teamContribute across the entire BMS hardware, wherever you are neededWhat You BringMust haveSolid foundation in electrical engineering, from the schematic to the PCB.
You know the parasitic effects of every practical circuit and you design with themDeep knowledge of power electronics: MOSFET switch design, SOA, gate drive, current sensing and loss budgetsExperience with protection circuits, e.
overcurrent, short circuit, over- and undervoltage, reverse polarityCircuit and thermal simulation, for example in LTspice, with model-to-hardware correlation on the benchConfident in the lab: oscilloscopes, power supplies, electronic loads, thermal measurements and of course hand-soldering 01005 componentsCritical, analytical, systematic thinking: you reason from first principles, make your assumptions explicit and challenge existing paradigmsStrongly preferredA broad.